Index

This is the alphabetical index for the RACKSYNC 3P-EMON SDM630MCT-RC manual. Key terms and cross-references:

A

• Accuracy — Chapter 2 (Specifications)
• AP Mode — Chapter 6 (Tasmota Setup)
• Apparent Power — Chapter 8 (Operation)

B

• Backlog command — Appendix C (Tasmota Commands)
• Baud rate — Chapter 5 (Meter Configuration)

C

• CAT III — Safety Warnings
• Certificate — Chapter 7 (TLS Security)
• Cloudflare Pages — Deployment
• Compliance — Chapter 2 (Specifications)
• CT ratio — Chapter 5 (Meter Configuration), Register 40063
• Current Transformer — Chapter 3 (CT Selection)

D

• Demand — Chapter 8 (Operation)
• Dimensions — Chapter 2 (Specifications)
• DIN rail — Chapter 4 (Installation)

E

• ESP32-C3 — Chapter 6 (Tasmota Setup)
• ESCT-RC — Chapter 3 (CT Selection)
• Energy counters — Chapter 8 (Operation)

F

• Firmware — Chapter 6 (Tasmota Setup), OTA Updates
• Frequency — Chapter 8 (Operation), Register 30061
• Frontmatter — Validation Schema

G

• GPIO — Chapter 6 (Tasmota Setup), GPIO6/GPIO7

H

• Home Assistant — Chapter 6 (Tasmota Setup), Auto-discovery
• HT-8WAY enclosure — Chapter 4 (Installation)

I

• IEEE 754 — Appendix A (Modbus Registers)
• Installation — Chapter 4
• IEC 62053-21 — Chapter 2 (Specifications)

K

• kWh — Chapter 8 (Operation), Energy Registers

L

• LCD display — Chapter 8 (Operation)
• Let's Encrypt — Chapter 7 (TLS Security)
• LOTO (Lock-out/Tag-out) — Safety Warnings

M

• mDNS — Chapter 6 (Tasmota Setup)
• MID 2014/32/EU — Chapter 2 (Specifications)
• Modbus RTU — Appendix A (Register Map)
• MQTT — Chapter 6 (Tasmota Setup)
• MQTT over TLS — Chapter 7 (TLS Security)

O

• OTA Update — Chapter 6 (Tasmota Setup)

P

• Parity — Chapter 5 (Meter Configuration)
• Power factor — Chapter 8 (Operation)
• PT ratio — Chapter 5 (Meter Configuration), Register 40065
• Pulse output — Chapter 4 (Installation)

R

• Reset — Appendix C (Tasmota Commands)
• Rogowski coil — Chapter 3 (CT Selection), Chapter 4 (Installation)
• RS485 — Chapter 4 (Installation), Appendix B (Wiring Diagrams)
• RS-EMON3P — Chapter 1 (Introduction), Product naming

S

• Safety warnings — Installation Safety
• Sarabar font — Build Configuration
• SDM630MCT-RC — Chapter 1 (Introduction), Chapter 2 (Specifications)
• SetOption — Appendix C (Tasmota Commands)
• System type (1P2W/3P3W/3P4W) — Chapter 5 (Meter Configuration)

T

• Tasmota — Chapter 6 (Tasmota Setup)
• TelePeriod — Appendix C (Tasmota Commands)
• Terminal pinout — Chapter 4 (Installation)
• TLS — Chapter 7 (TLS Security)
• Troubleshooting — Chapter 9

W

• Warranty — Warranty Terms
• Wi-Fi — Chapter 6 (Tasmota Setup)
• Wiring diagrams — Appendix B